More>>Contact
Tel： 0769 -85396950 / 85331816
Fax ： 0769 -82,288,950
Email:： yanhuajidian@163.com
Technical Director:： 18925811046 MR Liu
Business Consulting： 13415868989 Miss Cai
Address: Dongguan City Changan Wu Sha Lianguan Evergreen Commerce Building, 6B
Precautions installation of electric spindle
- Published：Update:2014-04-23 15:04:30
- Hits：
1 Before installing hand spindle rotation axis spindle head, you should feel a flexible, non-blocking phenomenon
2 Check the stator insulation resistance of not less than 100M
3 seat air motor into the machine, not loose
4 in strict accordance with the motor nameplate power inverter parameter settings (voltage, frequency, power)
5 spindle out of the pipes shall be connected as shown signs. Connections shall not leaking coolant must flow comfortable, otherwise spindle without water due to leaking or damaged water pipes should be reinforced rubber tube or plastic pipe, should be promptly replaced if the aging
6 Connect the power cord: motor leads should be soldered to the wiring 1,2,3, welded to the ground pin code 4 terminal blocks, the drive motor spindles cable as short as possible, up to not more than 25M
7 power cord should be waterproof measures in case of three-phase electrical short circuit, and to take measures to prevent high-frequency shielding for CNC machine control systems cause interference
8 Following the above steps to install, after inspection, before starting the spindle, if the operator is unclear, please contact us, remember to start running blind
2 Check the stator insulation resistance of not less than 100M
3 seat air motor into the machine, not loose
4 in strict accordance with the motor nameplate power inverter parameter settings (voltage, frequency, power)
5 spindle out of the pipes shall be connected as shown signs. Connections shall not leaking coolant must flow comfortable, otherwise spindle without water due to leaking or damaged water pipes should be reinforced rubber tube or plastic pipe, should be promptly replaced if the aging
6 Connect the power cord: motor leads should be soldered to the wiring 1,2,3, welded to the ground pin code 4 terminal blocks, the drive motor spindles cable as short as possible, up to not more than 25M
7 power cord should be waterproof measures in case of three-phase electrical short circuit, and to take measures to prevent high-frequency shielding for CNC machine control systems cause interference
8 Following the above steps to install, after inspection, before starting the spindle, if the operator is unclear, please contact us, remember to start running blind
- Previous: Installation of motorized spindle to note
- Next: Spindle Precautions;
- Tel：0769-85396950/85331816 Technical Director：18925811046 MR Liu Fax：0769-82288950
- Email：1270579410@qq.com Business Consulting：13415868989 Miss Cai
- Add：Lianguan Changan Town, Dongguan City, Evergreen Business Building, SE2/6B